Indicate Transmission Failure; Disable Character - Datalogic Touch 90 pro Product Reference Manual

Enter/Exit Programming Mode

Indicate Transmission Failure

This option enables/disables the reader's ability to sound an error beep to indicate a
transmission failure while in ACK/NAK mode.
$CR2TF01
Indicate Transmission Failure = Enable Indication

Disable Character

Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
page 258
$CR2DC
Select Disable Character Setting
32

for more detailed programming instructions.
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
as 7 Data Bits.
NOTE
0x44 = Disable Character is 'D'
DEFAULT
Indicate Transmission Failure
$CR2TF00
Indicate Transmission Failure = Disable Indication
DEFAULT
Data Bits

"Disable Character" on
has been set
Touch TD1100