Table of Contents
Advertisement
3.4.3
Configuring the Recording Duration
1.
In the OFF position, hold the
the switch to
emission of a beep, to enter the configuration mode. The display will
then indicate the recording interval.
NOTE: The default value is 60 seconds. Possible values range from 1 second to
600 seconds (10 minutes).
2.
To change the recording interval, press the
right-hand digit blinks. Each press on the
increments its value. To go to the next digit, apply a long press (>2s) to
the
3.
When the desired unit is displayed, turn the switch to another setting.
The unit chosen is stored and a double beep is emitted.
3.4.4
Erasing Recordings from Memory
To erase a recording from memory, perform the following:
NOTE: Make sure there is no voltage on the input terminals.
1.
In the OFF position, hold the
switch to
2.
The device emits a beep after erasing the records in memory. The "rSt"
and "rEC" symbols are displayed.
3.
The device then switches to normal continuity measurement.
3.4.5
Default Configuration
To reset the clamp-on meter to its default parameters (factory configuration):
1.
In the OFF position, hold the
switch to
The "rSt" symbol is displayed.
2.
After 2 s, the clamp-on meter emits a double beep, then all of the digital
symbols of the screen are displayed until the
released. The default parameters are then restored:
Recording interval = 60 seconds
Continuity detection threshold = 40
True InRush triggering threshold = 10%
, until the end of the "full screen" display and the
(yellow) button.
.
, until the "full screen" display ends and a beep is emitted.
(yellow) button down while turning
(yellow) button down while turning the
(yellow) button down while turning the
24
(yellow) button. The
(yellow) button
(yellow) button is
Advertisement
Table of Contents
