Board; Cn-3025 Board And Sw-1425 Board - Sony CBK-HD01 Maintenance Manual

7-7-7. KY-623 Board
1. Remove the inside panel. (Refer to Section 1-7-3.)
2. Remove the DCP-44 board. (Refer to Section 7-7-2.)
3. Remove the DVP-45 board. (Refer to Section 7-7-3.)
4. Open the key switch door.
5. Remove the two screws, key frame assembly and key
switch cover.
Key switch door
B2 x 4
2
1
6. Remove the harness holder rubber to release the
harness.
Harness hold rubber
7. Disconnect the harness from the connector (CN1) , and
remove the KY-623 board.
7-32
Key frame assembly
Key switch cover
8. Reinstall the removed parts by reversing steps 1 to 7 of

7-7-8. CN-3025 Board and SW-1425 Board

1. Remove the outside panel. (Refer to Section 1-7-1.)
2. Remove the inside panel. (Refer to Section 1-7-3.)
3. Remove the front panel. (Refer to Section 7-7-4.)
4. Remove the two screws (B2.6 x 5) , remove the SW-
5. Remove the two screws (B2.6 x 5) , remove the CN-
Harness
6. Reinstall the removed parts by reversing steps 1 to 5 of
KY-623 board
Harness
removal.

1425 board.

3025 board.
B2.6 x 5
SW-1425 board
CN-3025 board
Front panel
B2.6 x 5
removal.
n
Align the position of the switch (S1) on the SW-1425
board with the position of the VTR start button.
CN1
S1
VTR start button
LW2.6
PDW-700/V1 (E)