Servo2 Automatic Adjustment; Clearing Media Log; After Adjustment - Sony CBK-HD01 Maintenance Manual

8-5. Servo2 Automatic Adjustment

n
This adjustment is not available when the loader assembly
is removed. Be sure to install the loader assembly before
making this adjustment.
1. Clean the loader assembly. (Refer to Section 6-2-2.)
2. Install the loader assembly. (Refer to Section 7-1-1.)
3. Display the adjustment item referring to Section 8-1-3.
4. Select "SERVO_2" by turning the MENU knob, and
press the MENU knob. A confirmation screen appears.
5. Select "YES" by turning the MENU knob, and press
the MENU knob.
SERVO_2
ADJUST START?
*YES
NO
A confirmation screen appears.
SERVO_2
INSERT ALIGNMENT DISC
PFD23A-RS.
6. Set the alignment disc. The result appears.
SERVO_2
ADJUSTING...COMPLETED
7. Press the MENU switch. The alignment disc is ejected.
8-6

8-6. Clearing Media Log

m
. This menu is used to clear acquired media log.
Once this menu is executed, the cleared log data can no
longer be restored.
. The adjustment value is stored for each media.
If the optical drive is replaced, the adjustment value
differs from the one that is stored, so the media log needs
to be cleared.
1. Select "OTHERS ADJUST" by turning the MENU
knob, and press the MENU knob.
2. Select "CLEAR MEDIA LOG" by turning the MENU
knob, and press the MENU knob. A confirmation
screen appears.
3. Select "YES" by turning the MENU knob, press the
MENU knob.
CLEAR MEDIA LOG
ARE YOU SURE?
*YES
NO
The result appears.
EXECUTING...COMPLETED
4. Perform the procedure after adjustment.
(Refer to Section 8-7.)
In case of error:
The defect in the EEPROM (IC4/SE-857 board) is thought.
CLEAR MEDIA LOG
EXECUTING...FAILED

8-7. After Adjustment

1. Turn off the power.
2. Reinstalled the outside panel. (Refer to Section 1-7-2.)
PDW-700/V1 (E)