Sony CBK-HD01 Maintenance Manual page 241

Reinstallation
n
When installing, take care so that the torsion
spring and CL spring do not come off.
1. Rotate the gear (A) to move the cartridge
holder in the direction of the arrow until it
will stop.
2. Connect the harness to the connector
(CN709) on the SE-857 board.
3. Insert the upper part of the loader assembly
underneath the portion "A" of the base plate
assembly, and align the four positioning pins
of the base plate assembly with the four holes
of the loader assembly as shown in Fig.1.
4. Reinstall the loader assembly in the base
plate assembly, and fix it using the two
screws with drop-safe stoppers.
n
Confirm that the LD spacer is correctly
installed in the positioning pin-A (at two
locations).
5. Connect the flexible card wire to the connec-
tor (CN1) on the SW-1125G board.
6. Reinstall the SW guard assembly.
(Refer to Section 1-7-6.)
PDW-700/V1 (E)
Cartridge holder
Gear(A)
Loader
assembly
Hole
Pin-B
Base plate
assembly
CN1/SW-1125G board
Flexible card
wire
Pin-B
Tension spring
CL spring
Cleaner
assembly
Loader assembly
Fig.1
Base plate
assembly
Hole
Loader
assembly
A
Pin-A
LD spacer
Loader
assembly
CN709/SE-857 board
Harness
Hole
Pin-A
7-3