Sony CBK-HD01 Maintenance Manual page 282

8. Select "YES" by turning the MENU knob, and press
the MENU knob.
The result on the tangential OUT side appears.
9. If the adjustment failed in step 8, repeat steps (1) to (2)
until satisfactory result is obtained.
(1) Turn the tangential OUT adjustment screw.
m
. The adjustment screw should be turned clockwise
for this adjustment. If they are turned too much, turn
them back sufficiently, and turn them clockwise
again.
. If measured data is +, turn the adjustment screw
clockwise.
. If measured data is _, turn the adjustment screw
counterclockwise.
(2) Press the [SET] button.
The result on the tangential OUT side appears.
TAN ADJUST
OUTSIDE ADJUST
MEASURE TAGET
+0.007 DEG: NG
ARE YOU NEXT
YES
*NO
Tangential OUT adjustment screw
10. When the result is satisfactory, select "YES" by
turning the MENU knob, and press the MENU knob.
("YES" cannot be selected when the result is not
satisfactory.)
TAN ADJUST
OUTSIDE ADJUST
MEASURE TAGET
+0.007 DEG: OK
ARE YOU NEXT?
*YES
NO
11. The result on the tangential IN side appears.
8-4
12. If the adjustment failed in step 11, repeat steps (1) to
(2) until satisfactory result is obtained.
(1) Turn the tangential IN adjustment screw.
m
. The adjustment screw should be turned clockwise
for this adjustment. If they are turned too much, turn
them back sufficiently, and turn them clockwise
again.
. If measured data is +, turn the adjustment screw
counterclockwise.
. If measured data is _, turn the adjustment screw
clockwise.
(2) Press the [SET] button.
The result on the tangential IN side appears.
TAN ADJUST
INSIDE ADJUST
MEASURE TAGET
-0.009 DEG: NG
ARE YOU NEXT
YES
*NO
Tangential IN
adjustment screw
13. When the result is satisfactory, select "YES" by
turning the MENU knob, and press the MENU knob.
14. The tangential skew adjustment result appears.
When "ERROR" appears, press the MENU knob to
make adjustment from step 6.
TAN ADJUST
CHECKING...OK
PDW-700/V1 (E)