Sony CBK-HD01 Maintenance Manual page 251

Reinstallation
1. Install the No.2 gear onto the base plate shaft.
2. Align the upper and lower holes of the No.3
gear assembly while turning the No.3 gear
assembly, and insert the parallel pin into the
holes.
3. Install the No.3 gear assembly onto the base
plate.
n
Install the No.3 gear assembly so that the
gear of the No.3 gear assembly is properly
engaged with the gear of the OP rack assem-
bly and with the No.2 gear.
4. Attach two stopper washers to the two shafts
of the base plate.
5. Pull out the two parallel pins.
6. Press the die-casting part or the connector of
the optical block assembly, and check the
following:
. The optical block assembly moves smooth-
ly.
. The OP rack assembly and the No.3 gear
assembly are not disengaged.
7. Reinstall the removed parts by reversing
steps 1 to 7 of removal.
PDW-700/V1 (E)
Stopper washer
No.3 gear
Parallel pin
assembly
Stopper washer
No.2 gear
Parallel pin
Optical block assembly
7-13