Internal Board - Sony BVP-E10 Series Product Information Manual

7
Chapter 7 Location and Function of Parts and Controls
78
BVP-E10 Series Product Information Manual
7-8-2

Internal Board

1 +5 V indicator
2 OPERATION switch
a +5 V indicator a
a a
Illuminates when +5 V power is supplied to the board.
b b OPERATION switch b b
NORMAL: Set to this position for normal operation.
EMERGENCY: Set to this position when the CNU-
500 or MSU-700 cannot function normally, to
bypass the CNU. The RCP-700 Series Remote
Control Panels are directly connected to their
respective camera control units.
The switch is set to NORMAL at the factory.
c MODE switch c
c c
0: Factory setting
1: When the switch is set to this position, the UP/
DOWN switch is activated, and the switch changes
the character page displayed on a monitor
connected to the CHARACTER connector.
2 through F: Not used.
d UP/DOWN switch d
d d
Changes the page displayed on the monitor screen.
This switch functions only when the MODE switch is set
to 1. The contents of each page are shown in the
following table.
Page Contents
Nothing appears when power is turned on.
Shows a warning if a problem is detected by
the self-diagnosis of the camera.
Connection status of Cameras 1 through 6.
Not used.
Not used.
Shows the results of auto set-up of Camera 1
through 6.
Cannot be used.
DIAGNOSIS OF ALL CAMERAS displays,
which shows the results of the self-diagnosis
of all the cameras.
Not used.
DIAGNOSIS OF ONE CAMERA display,
which shows the results of the self-diagnosis
of the selected camera.
DATA OF ALL CAMERAS display, which
shows the setting status of each camera.
DATA OF ONE CAMERA display, which
shows the setting status of the selected cam-
era.
OPERATION
+5
NORMAL EMERGENCY
3 MODE switch
4 UP/DOWN switch
5 SET/CANCEL switch
e SET/CANCEL switch e
e e
Selects the displayed item or camera (CAM) when
display page 9, 10 or 11 appears on the monitor
screen.
f f f f SYNC ON/OFF switch
Selects whether the sync signal is to be added to the
video signal output from the CHARACTER connector.
At the factory, the switch is set to ON (added).
g g CHARACTER PHASE control g g
Adjusts the horizontal phase of the signal output from
the CHARACTER connector, referring to the reference
signal. Adjust the phase by monitoring the signal on
the monitor screen.
MODE
SYNC
CHARACTER
UP DOWN SET CANCEL PHUSE OFF ON
6 SYNC ON/OFF
switch
7 CHARACTER
PHASE control