Sony CBK-HD01 Maintenance Manual page 260

2. Install the SE-858 board with seven screws in
the order of the numbers shown in the figure.
Tightening torque:
± 0.01 N.m (1.0 ± 0.1 kgf.cm)
10 x 10 _2
3. Connect the flexible card wire to the connec-
tor CN600.
n
The flexible card wire connected to CN600
has a conductive area on both sides, and the
tip on the reverse side is insulated. Insert the
flexible card wire into the connector as far as
it will go, and then lock it.
4. Connect the harness to the connector CN2.
5. Reinstall the removed parts by reversing
steps 1 to 5 of removal.
7-22
Obverse side
Conduction
Screws (M1.7)
6
5
Screws
(M1.7)
CN2
1
4
2
Reverse side
Insulation
Conduction
7
CN600
Screw
(M1.7)
3
SE-858 board
PDW-700/V1 (E)