Log Installation - kozy heat Chaska CSK-31 Installation And Operating Manual

K. LOG INSTALLATION - Log Set #CSK-500
This log set includes 11 logs and 1 pkg. rock wool burning embers.
Note: Each log is numbered on the bottom and should be installed according to the
instructions and diagrams below.
1. Install base logs, C1, C2, C3, onto the burner as
shown in Figure K-1, aligning the mounting holes in
the bottom of the logs to the mounting studs in the
burner.
IMPORTANT: Push the logs down onto the
mounting studs so that the logs will be setting on
the burner assembly.
2. Install the ember logs, C9, C10 & C11 onto the front
of the burner as shown in Figure K-1.
3. Install middle log C4, and top logs C5, C6, C7, & C8
onto the base logs as shown in Figure K-2, aligning
the logs to the corresponding notched out sections
in the base logs.
Place rock wool burning embers as desired onto the logs and burner to enhance glowing effect and flame appearance.
NOTE: You will not use all the rock wool ember material at this time. Save
for future use.
Completed Log Set Installation
Page 16
C2
C10 C9
Figure K-1
C5
C8
Figure K-2
C1
C3
C6
C4
C11
C7