Insert Preparation; Remove The Glass Assembly; Remove The Air Duct - kozy heat Chaska CSK-31 Installation And Operating Manual

C. REMOVE THE FOLLOWING ITEMS FROM THE FIREPLACE INSERT:
1. GLASS ASSEMBLY:
A) Locate the spring-loaded latches securing the
glass assembly (under the firebox).
B) While holding onto the glass frame, pull the
latch handles out, then down to release from
the clips on the glass assembly.
C) Lift the glass assembly up off the tabs at the
top of the firebox.
D) Pull the bottom of the glass assembly out and
remove.
E) Set aside where it will not be broken.
2. REMOVE THE AIR DUCT. Figure C-2.
A. Remove the air duct, located at the top of the insert, by sliding it back out of the channel.
Figure C-2
Figure C-1
Air Duct
Page 6