kozy heat Chaska CSK-31 Installation And Operating Manual page 25

*If knob does not pop out when released, stop and immediately call your service technician or gas supplier.
*If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier.
9. Push the control knob on the gas valve in slightly and turn counterclockwise
LOCAL position, the main burner will turn on immediately.
IMPORTANT: On the initial use of a transmitter, a recognition operation
is required between the receiver / valve and the transmitter.
1. Turn the gas control to the PILOT position.
2. Move the LOCAL / REMOTE switch to the LOCAL position for at least two
seconds, then move the switch to the REMOTE position.
3. Press the FAN or FLAME button on the transmitter within 30 seconds
of the switch change.
4. Turn the gas control knob to the ON position.
The LED will blink indicating that the transmitter will now work with the receiver / valve. If the switch stays in the REMOTE position,
the RT8220A Transmitter will control the main valve, flame modulation level and fan control.
If the LOCAL / REMOTE switch is in the LOCAL position, the receiver / valve will be at the highest fixed pressure setting.
NOTE: When this fireplace insert is initially lit, condensation will appear on the glass, this is normal in all gas fireplaces, and will
disappear as the fireplace heats.
TO TURN THE BURNER OFF:
LOCAL SETTING: Turn the control knob clockwise to the pilot position.
REMOTE SETTING: The RT8220A transmitter can shut off the main burner and fan, however, the control is still 'ON' and a command from
the transmitter can turn the main burner and fan 'ON'.
TO TURN OFF THE SYSTEM:
1. Open the doors or lower grill to access the gas valve & controls.
2. Turn the gas control knob clockwise to the 'OFF' position. This closes the main gas and safety valves. The transmitter cannot turn
on the main burner or the fan.
NOTE: A PAINT SMELL WILL OCCUR DURING THE FIRST FEW HOURS OF BURNING. IT IS RECOMMENDED TO LEAVE THE FAN OFF
DURING THIS PERIOD AS THIS WILL SPEED UP THE PAINT CURING PROCESS.
DUE TO THE MAKEUP OF THE FIBER LOGS & REFRACTORY, THE CURING PROCESS MAY TAKE UP TO 4 HOURS OF BURN TIME. DURING THIS PERIOD, THE LOGS
& REFRACTORY WILL DISCOLOR, BUT WILL RETURN TO THEIR TRUE COLOR ONCE THE CURING PROCESS IS COMPLETE. DO NOT BURN THIS FIREPLACE
WITHOUT THE GLASS PROPERLY IN PLACE.
NOTE: Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or
clothing ignition. Young children should be carefully supervised when they are in the same room as the appliance.
Clothing or other flammable material should not be placed on or near the appliance.
NOTE: THIS FIREPLACE MAY PRODUCE NOISES OF VARYING DEGREE AS IT HEATS AND COOLS DUE TO
METAL EXPANSION AND CONTRACTION.
PERFORMANCE OR LONGEVITY OF THE FIREPLACE.
INITIAL BURN PERIOD
**MAKE SURE THE HOMEOWNER IS AWARE OF THIS**
THIS IS NORMAL AND DOES
Page 23
to the "ON" position. If the manual switch is in the
Figure N-3
NOT AFFECT THE