Safety Instructions - Kipor Sinemaster IG200 Operation Manual

14. LIGHT KIT
MOUNTING INSTRUCTIONS FOR: IG2000s LIGHT KIT
M5 Nut
M5 65
Our IG2000s Light kit is designed specifically for use on IG2000 Generator.
Tools required: Phillips Screwdriver
Fittings supplied:
(1) IG2000 Portable Digital Generator
(2) KGE2000Tsi-05100 Light Kit Assembly
(3) KGE1000Tsi-05001a Nut
(4) KGE1000Tsi-05002a Threaded screw
(5) KGE2000Tsi-05003 Left Mount Plate of Light Housing
(6) KGE2000Tsi-05004 Right Mount Plate of Light Housing
(7) Screw M5 65 2PCS
(8) Screw M5 16 1PCS
(9) Nut M5 1PC
This is where the Light Kit will be mounted, see IG2000s Assembly Drawing of the Portable
Digital Generator Light Kit.
(1) Remove the screw from the IG2000 Portable Digital Generator and the screws from the
side of the control plate;
(2) Disperse the mount plate of the Light, use screw M5
the mount plate of Light Housing on generator. DO NOT TIGHTEN SCREWS.
(3) Use the threaded screw through the Light, left and right mount plate in turn, then lock the
nut.
(4) After adjusting the turnover angular of Light, tighten the avove mentioned of threaded
screw, screw M5 65 and screw M5 16 in turn.
Before energizing the light, be sure to read the Generator Owner's Manual for best operation
and maintenance information, along with the safety precautions. It is recommended that the
light switch be in the OFF position when starting the generator.
M5 16
M5 65
65 and screw M5 16, then locate
- -

1. SAFETY INSTRUCTIONS

To ensure safe operation
WARNING
The generators are designed to give safe and depend-
able service if operated according to instructions.
Read and understand the Owner's Manual before op-
erating the generator. Failure to do so could result in
personal injury or equipment damage.
WARNING
Exhaust gas contains poisonous carbon monoxide.
Never run the generator in an enclosed area.
Be sure to provide adequate ventilation.
WARNING
The muffler becomes very hot during operation and
remains hot for a while after stopping the engine.
Be careful not to touch the muffler while it is hot.
Let the engine cool before storing the generator indoors.
The engine exhaust system will be heated during
operation and remain hot immediately after stopping
the engine.
To prevent scalding, pay attention to the warning marks
attached to the generator.