Stopping The Engine - Kipor Sinemaster IG200 Operation Manual

7. STOPPING THE ENGINE

To stop the engine in an emergency, turn the engine switch to the OFF position.
IN NORMAL USE:
1.Switch off the connected equipment and pull the inserted plug out.
PLUG
2.Turn the engine switch to the OFF position
ENGINE SWITCH
ON
OFF
OFF
DC application
The DC receptacle may be used for charging 12 volt automotive-type batteries only, the
zero load voltage is 15V-30V.
NOTE
In DC operation, turn the Smart-throttle switch to the OFF position.
1. Connect the charging cables to the DC receptacle of the generator and then to the ba-
ttery terminals.
WARNING
To prevent the possibility of creating a spark near the battery, connect charging
cable first to the generator, then to the battery. Disconnect cable first at the
battery.
Before connecting charging cables to a battery that is installed in a vehicle,
disconnect the vehicles grounded battery cable. Reconnect the vehicle's
grounded battery cable after the charging cables are removed. This procedure
will prevent the possibility of a short circuit and sparks if you make accidental
contact between a battery terminal and the vehicle's frame or body.
CAUTION
Do not attempt to start an automobile engine with the generator still connected
to the battery. The generator may be damaged.
Connect the positive battery terminal to the positive charging cord. Do not re-
verse the charging cables, or serious damage to the generator and/or battery
may occur.
CHARGING CABLE
(SOLD SEPARATELY)