Double Generators Parallel - Kipor Sinemaster IG200 Operation Manual

8. DOUBLE GENERATORS PARALLEL (Limited to the
IG2000p has parallel function)
Control panel
Parallel output receptacle
Parallel connection interface
DC circuit protection device
DC receptacle
Grounding terminal
Smart-throttle switch
Output indicator
Overload alarm
Low oil alarm
AC receptacle
AC applications
1. Start the engine and make sure only the output indicator light (green) comes on.
2. Confirm that the appliance to be used is switched off, and plug in the appliance.
OUTPUT INDICATOR LIGHT
OVERLOAD INDICATOR
LIGHT
CAUTION
Substantial overloading that continuously lights the overload indicator light
(red) may damage the generator. Marginal overloading that temporarily lights
the overload indicator light (red) may shorten the service life of the generator.
Be sure that all appliances are in good working order before connecting them
to the generator. If an appliance begins to operate abnormally, becomes
sluggish, or stops suddenly, turn off the generator engine switch immediately.
Then disconnect the appliance, and examine it for signs of malfunction.
3. In order to acquire both the best effect and the maximum service life of the
generator. Usually, the new generator should run 20 hours under 50% load, the
generator may reach the best performance.
PLUG