Kipor Sinemaster IG200 Operation Manual page 22

CAUTION
Do not exceed the rated power.
The total wattage of all appliances connected must be considered.
Do not exceed the current limit specified for any one receptacle.
Do not connect the generator to a household circuit. This could cause the
damage to the generator or to electrical appliances in the house.
Do not modify or use the generator for other purpose than it is intended for.
Also observe the following when using the generator.
Do not connect an extension to exhaust pipe.
When an extension cable is required, be sure to use a rubber sheathed
flexible cable (IEC 245 or equivalent).
Limit length of extension cables; 60m for cables of 1.5mm and 100m for
2
cables of 2.5mm . Long extension cables will reduce usable power due to
resistance in the extension cable.
Keep the generator away from other electric cables or wires such as
commercial power supply lines.
NOTE
The DC receptacle can be used while the AC power is in use. If you use both
at the same time, be sure not to exceed the total power for AC and DC.
Most appliance motors require more than their rated wattage for start-up.
Parallel operation features:
Two pieces of our IG2000p can be
paralleled to increase the total
output.
Parallel operation procedure:
1. Prepare two generators of
IG2000p.
Note: Turn off both generators
(engines) and disconnect all the
e l e c t r i c a l d e v i c e s f r o m t h e
generators.
2
2. First please connect two
our special parallel communication cable, and then tighten up the plug. Fig. 3
3. Secondly, securely plug the connector plugs
connector receptacles PARALLEL OUTPUT
4. Connect the ground terminals
of the two generators.
Note: Make sure to ground the electrical device
both generators must be placed on the hard and flat surface.
PARALLEL I/O terminals on each control panels with
of the parallel cable
located on the control panels Fig.4
of the parallel cable to the ground terminals of each
Fig. 4
being used is grounded. Besides,
Fig. 1
Fig. 2
into the