Kipor Sinemaster IG200 Operation Manual page 12

Smart throttle
Engine speed is kept at idle automatically when the electrical appliance is disconnected
and it returns to the proper speed to power of the electrical load when electrical
appliance is connected. This position is recommended to minimize the fuel consumption
while in operation.
WARNING
Smart throttle system does not operate effectively, if the electrical appliance
requires the momentary electric power.
When high electrical loads are connected simultaneously, turn the Smart-
throttle switch to the OFF position to reduce voltage vibration.
In DC operation, turn the Smart-throttle switch to the OFF position.
OFF:
Smart-throttle system does not operate. Engine speed is kept over rated speed.
OFF
ON
ON
OFF
10. TRANSPORTING STORAGE
To prevent fuel spillage when transporting or during temporary storage, the generator
should be secured upright in its normal operating position, with the engine switch OFF.
The fuel cap vent lever is turned counterclockwise to the OFF position.
Allow the engine to cool well before turning the fuel cap vent lever to the OFF position.
WARNING
When transporting the generator:
Do not overfill the tank (there should be no fuel in the filler neck).
Do not operate the generator while it is on a vehicle. Take the generator off the
vehicle and use it in a well ventilated place.
Avoid a place exposed to direct sunlight when putting the generator on a
vehicle. If the generator is left in an enclosed vehicle for many hours, high
temperature inside the vehicle could cause fuel to vaporize resulting in a
possible explosion.
Do not drive on a rough road for an extended period with the generator on
board. If you must transport the generator on board. If you must transport the
generator on a rough road, drain the fuel from the generator beforehand.
Before storing the unit for an extended period:
1. Be sure the storage area is free of excessive humidity and dust.
2. Drain the fuel.
WARNING
Gasoline is extremely flammable and explosive under certain conditions.
Do not smoke or allow flames or sparks in the area.
SCREW DRIVER
- -