Table of Contents
Advertisement
3.2: ANSI Installation Steps
1. Insert 4 threaded rods by hand into the back of meter. Twist until secure.
2. Slide NEMA 12 Mounting Gasket onto back of meter with rods in place.
3. Slide meter with Mounting Gasket into panel.
4. Secure from back of panel with lock washer and nut on each threaded rod.
Use a small wrench to tighten. Do not overtighten. The maximum installation torque
is 0.4 Newton-Meter.
e
Electro Industries/Gauge Tech
NEMA 12 Mounting Gasket
Threaded Rods
Figure 3.7: ANSI Mounting Procedure
Doc# E149701
Lock Washer
and Nut
3-3
Advertisement
Table of Contents
