Table of Contents
Advertisement
5.2: Shark ® 200T Transducer Communication and Programming Overview
®
The Shark
200T transducer does not include a display on the front face of the meter; there are no buttons or IrDA
Port on the face of the meter. Programming and communication utilize the RS485 connection on the back face of
the meter shown in section 5.1.2. Once a connection is established, Communicator EXT 3.0 software can be used
to program the meter and communicate to Shark
Meter Connection
To provide power to the meter, attach an Aux cable to GND, L(+) and N(-) Refer to Section 4.8, Figure 1.
The RS485 cable attaches to SH, B(-) and A(+) as shown in Section 5.1.2.
5.2.1: Factory Default Settings
®
When the Shark
Initial Default Settings (even if the Device Profile has been changed). After 10 seconds, the Device Profile reverts
to the actual Device Profile in use. This is one way that you can always connect to the meter.
Factory Initial Default Settings
Baud Rate:
Port:
Protocol:
How to Connect:
1. Open Communicator EXT software.
2. Click the Connect icon on the Title bar.
The Connect screen opens, showing the Default settings.
Make sure your settings are the same as shown here. Use the
drop-down menus to make any necessary changes to the settings.
3. Click the Connect button. If you have a problem connecting,
you may have to disconnect power to the meter, reconnect
power, and click the Connect button, again.
e
Electro Industries/Gauge Tech
200T transducer is powered up, for 10 seconds you can connect to the meter using the Factory
9600
COM1
Modbus RTU
®
200T transducer slave devices.
Doc# E149701
Connect Icon
5-6
Advertisement
Table of Contents
