Pulse Output (Solid State Relay Contacts) / Digital Input Card (P01S) - Electro Industries Shark 200 Installation & Operation Manual

Low-cost high performance multifunction electricity meter
Hide thumbs Also See for Shark 200:
Table of Contents

Advertisement

7.7: Pulse Output (Solid State Relay Contacts) / Digital Input Card (P01S)

The Pulse Output/Digital Input card is a combination of pulse outputs via solid state contacts and dry/wet contact
sensing digital inputs. The outputs are electrically isolated from the inputs and from the main unit.
7.7.1: Specifications
The technical specifications at 25 °C are as follows:
Power consumption:
Relay outputs
Number of outputs:
Contact type:
Relay type:
Peak switching voltage:
Continuous load current:
Peak load current:
On resistance, max.:
Leakage current:
Switching Rate max.:
Isolation:
Reset/Power down state:
Inputs
Number of inputs:
Sensing type:
Wetting voltage:
Input current:
Minimum input voltage:
Maximum input voltage:
Filtering:
Detection scan rate:
Isolation:
The general specifications are as follows:
Operating Temperature:
Storage Temperature:
Relative air humidity:
EMC - Immunity Interference:
Weight:
Dimensions (inch) W x H x L:
External Connection:
7.7.2: Default Configuration:
The Shark ® 200 meter automatically recognizes the installed option card during Power Up. If you have not pro-
grammed a configuration for the card, the unit will default to the following outputs:
Status Inputs
Pulse Outputs
Pulse Channel 1 1.8 +Watt-hrs per pulse
Pulse Channel 2 1.8 -Watt-hrs per pulse
Pulse Channel 3 1.8 +VAR-hrs per pulse
Pulse Channel 4 1.8 -VAR-hrs per pulse
e
Electro Industries/Gauge Tech
Defaulted to Status Detect
Defaulted to Energy Pulses
0.420W internal
4
Closing (SPST - NO)
Solid state
DC ±350V
120mA
350mA for 10ms
35Ω
1µA@350V
10/s
AC 3750V system to contacts
Open contacts
4
Wet or dry contact status detection
DC (12-24)V, internally generated
2.5mA – constant current regulated
0V (input shorted to common)
DC 150V (diode protected against polarity reversal)
De-bouncing with 50ms delay time
100ms
AC 2500V system to inputs
(-20 to +70) °C
(-40 to +80) °C
Maximum 95%, non-condensing
EN61000-4-2
1.3oz
0.72 x 2.68 x 3.26
AWG 12-26/(0.129 - 3.31)mm
13 pin, 3.5mm pluggable terminal block
Doc# E149701
2
7-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shark 200t

Table of Contents