Using the USB to IrDA Adapter (CAB6490)
D.1: Introduction
®
Com 1 of the Shark
communicate with the IrDA port is with EIG's USB to IrDA Adapter (CAB6490), which allows you to
®
access the Shark
200 meter's data from a PC. This Appendix contains instructions for installing the
USB to IrDA Adapter.
D.2: Installation Procedures
The USB to IrDA Adapter comes packaged with a USB cable and an Installation CD. Follow this
procedure to install the Adapter on your PC.
1. Connect the USB cable to the USB to IrDA Adapter, and plug the USB into your PC's USB port.
2. Insert the Installation CD into your PC's CD ROM drive.
3. You will see the screen shown below
software for the Adapter. Click the Radio Button next to Install from a list or specific location.
4. Click Next. You will see the screen shown on the next page.
E
Electro Industries/Gauge Tech
Appendix D
200 meter is the IrDA port, located on the face of the meter. One way to
.
The Found New Hardware Wizard allows you to install the
Doc# E149701
D-1