Chapter 7. SLT Features
To use Reset Call to dial another extension (after a busy extension):
1. Lift the handset.
2. Dial an extension.
3. Enter the last digit of the next extension.
Example: You dial extension 213, but it is busy. To dial extension 214, enter 4.
Hardware Requirements
•
N/A
Related Programming
•
FF1-2: Dial Plan
Considerations
•
The second extension called using the Reset Call feature must have the same number of digits as
the first extension.
Room Monitoring
Description
This feature allows the user to monitor the sounds in a room from another extension or room. The
transmitter in the telephone handset is used as a remote "microphone" for monitoring these sounds.
To activate this feature, the monitored extension must enable the Room Monitor feature before the
monitoring extension can listen to the sounds in the room. The monitored extension can be enabled
using an SLT, DSLT, or Key Telephone. No special programming is required to allow an extension to
enable the monitored mode.
Operation
To set up the monitored extension:
1. Dial the monitored extension access code (default 775)
Note: The handset must be off-hook to activate the
Room Monitor feature.
7-34
Action
Action
DBS 576 (USA) issued April 2002
Section 700 - Operation
Result
Intercom dial tone
Busy tone
Result
You will hear a confirmation tone after
the monitored extension has enabled the
Room Monitor feature.
576-51-700