Panasonic DBS 576 Technical Manual page 173

Section 700 - Operation
Operation
To assign Fixed Feature codes to an FF key:
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key to be programmed.
4. Press the REDIAL key.
5. Enter the code to be programmed. (See Table 5 on page 5-
49.)
6. Press the HOLD key.
7. Repeat steps 2-6 to program additional keys.
8. Replace the handset or press the ON/OFF key.
To assign Flexible Feature Codes to an FF key:
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key to be programmed.
4. Enter the code to be programmed. (See Table 5 on page 5-
49.)
5. Press the HOLD key.
6. Repeat steps 2-5 to program additional keys.
7. Replace the handset or press the ON/OFF key.
To erase a code stored on an FF key:
Note: You cannot use the following procedure to clear FF keys that have been assigned as CO lines.
CO line keys can only be cleared through system programming.
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key that was programmed.
4. Press the HOLD key.
576-51-700
Action
Action
Action
DBS 576 (USA) issued April 2002
Chapter 5. Key Telephone Features
Result
Intercom dial tone
F displays
Enter Function# displays
Programmed code displays
Programmed function name displays
Result
Intercom dial tone
F displays
Enter Function# displays
Programmed code displays
Programmed function name displays
Result
Intercom dial tone
Programmed code displays
Cleared Function displays
5-47