Parameters That Are Changed When "Enhance Security" Is Set - Konica Minolta bizhub 362 User Manual

12

Parameters that are changed when "Enhance Security" is set

When "Enhance Security" is set to "ON", settings for the following
parameters are forcibly changed in order to enhance security. The changed
parameters do not return to their original settings, even after "Enhance
Security" is canceled. Before setting "Enhance Security" to "ON", carefully
check the parameters that are to be changed.
Changed parameters
Password rules
Access locks
Software SW
Button display in the User Au-
thentication screen
Allow Print without Authentica-
tion
Auto Reset
Restrict One Touch Editing
Temporary overwrite data
Cancel HDD Locking Password
12-70
Details of change
Password rules are applied.
This parameter is enabled. If the password for an operation re-
quiring a password is incorrectly entered three consecutive
times, the password can no longer be entered.
The software switch settings cannot be changed.
[User List] does not appear.
This parameter cannot be used.
This parameter cannot be set to "OFF".
If this parameter is set to "OFF" before "Enhance Security" is
set to "ON", this parameter will change to "1 min."
"Restrict One Touch Editing" is set to "ON".
"Temporary overwrite data" is set to "ON".
The hard disk locking password setting can no longer be
changed.
Utility mode
bizhub 362/282/222