Before Specifying The "Enhance Security" Parameter - Konica Minolta bizhub 362 User Manual

Utility mode

Before specifying the "Enhance Security" parameter

The following settings must first be specified in order to set "Enhance
Security" to "ON".
Administrator Management screen
Admin. Set—Administrator Code Input
HDD Management—HDD Lock Setting
Encryption Setting
Note
"HDD Management" appears in the Administrator Management screen
only when the optional hard disk drive is installed.
Certain conditions must be met, for example, an SSL certificate must be
registered, service codes must be changed and CS remote care must be
canceled, in order for the enhanced security features to be applied. For
details on registering an SSL certificate, refer to the User manual
[Network Scanner Operations]. For details on changing service codes
and canceling CS remote care, contact your technical representative.
!
Detail
For details on the password rules, refer to "Password rules" on
page 12-78.
To cancel encryption settings, set "Enhance Security" to "OFF", erase all
data from the memory, and then turn the machine off, then on again with
the main power switch to initialize it. For details on managing the hard
disk, refer to the User manual [Box Operations].
bizhub 362/282/222
Settings
Specify a password that meets the password rules.
If the specified password does not meet the pass-
word rules, "Enhance Security" can be set to "ON";
however, the password will be invalid when it is en-
tered in the Administrator Management screen.
If the optional hard disk drive is installed, a 20-digit
hard disk locking password will be specified.
If security kit SC-504 is installed, encryption is spec-
ified. Either a locking password or encryption must
be specified.
12
12-69