Utility mode
2
Touch [Overwrite All Data].
The Overwrite All Data screen
appears.
3
Touch [Yes], and then touch [Enter].
Wait until the message "All data has
been overwritten." appears.
Note
If a job is being performed, the message "Cannot start because there is
an unfinished job." appears. Touch [Enter] to return to the previous
screen, make sure that the job is completed, and then select the
"Overwrite All Data" parameter again.
If the message "Failed to overwrite All Data. ..." appears, turn the
machine off with the main power switch, wait about 10 seconds before
turning it on again, and then select the "Overwrite All Data" parameter
again.
bizhub 362/282/222
12
12-77