Table of Contents
Advertisement
RADIATOR AND GRILLE 13-5
Fig. 4 - Radiator and Shroud - Corvette
attaching top of grille to left and
GRILLE ASSEMBLY—CORVETTE (Fig. 10)
10.
Remove screws
right supports.
Remove rivets securing bottom of grille to filler
panel, support assemblies, and reinforcements and
remove grille from vehicle.
If necessary, remove rivets, screws, and retainers
securing reinforcements and name plate to grille and
replace reinforcements and name plate.
Remove screws attaching left and right supports and
remove supports.
Remove attaching hardware securing filler panel and
remove filler panel from vehicle.
Repair
If any components removed are undamaged, they may
be Used for the new grille installation. Where rivets
were removed, make new attachments using screws and
nuts, patent clips, or rivets.
Installation
Install grille and related components following the re-
moval procedure in reverse order. Refer to torque spec-
ifications in rear of manual for correct torque values.
Removal
1. Raise front of vehicle.
2. Remove front bumper (Section 14).
3. Remove grille retaining screws.
4. Remove grille from vehicle.
Installation
Install grille and related components following the re-
moval procedure in reverse order. Refer to torque spec-
ifications in rear of manual for correct torque values.
GRILLE ASSEMBLY-CAMARO (Fig. 11)
NOTE:
If necessary to remove retractable
headlamp cover only, refer to Section 12.
Removal
1. Raise hood and disconnect battery leads and remove
battery.
2. Remove bumper (Section 14).
3. Remove screws securing hood catch assembly to
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
