Table of Contents
Advertisement
ELECTRICAL-BODY AND CHASSIS 12-18
TO BACK UP
LAMP SWITCH
TO STOP LAMP
SWITCH
Fig. 29 - Backing Lamp Switch on Mast Jacket (Chevelle)
tray, trim plate assembly, and indicator lens and
housing from console.
Disconnect bulbs from housing. Disconnect multiple
connector at switch terminals or on Camaro models
from the wiring harness at the in-line connector.
Remove switch retaining nuts and switch.
Tp install new switch, clamp pawl rod against contact
point "B" of detent and align slot in contact support
6.
7.
with drive hole in switch and insert a pin (3/32" dia.)
to hold in place. Switch is now in drive position.
Position switch to lever and bracket assembly with
lever engaged in contact support and install retaining
nuts.
Remove clamp and pin, connect wiring and check op-
eration of switch.
Install indicator lamps, housing, lens, ash tray and
trim plate assembly.
Corvette {Fig. 32)
1. Disconnect shift control lever arm from the control
rod.
2. Remove the shift control knob.
3. Remove Trim Plate retaining screws and trim plate
assembly.
4. Remove control assembly retaining screws.
5. Remove control assembly from the seal and cut
switch wiring.
6. Remove switch retaining nuts and switch from, the
control assembly.
7. To install, position gearshift in "Drive" position
align hole in contact support with hole in switch and
insert pin (3/32" dia.) to hold support in place.
8. Place the contact support drive slot over the drive
tang and tighten switch mounting screws.
9. Splice wiring harness to switch wiring.
10. Install trim plate assembly and shift lever control
knob.
11. Connect shift lever arm to the transmission control
Fig. 30 - Backing Lamp Switch on Transmission
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
