Wheel Spindle And Support Cross-Section; Bearing Cup Removal (Corvette); Installing Spindle Bearing Cup (Corvette); Unseating Drive Spindle Outer Bearing (Corvette) - Chevrolet 1967 Chevelle Service Manual

Hide thumbs Also See for 1967 Chevelle:

Table of Contents

REAR SUSPENSION AND DRIVE LINE 4-19

-. -, -«#*;>•

Fig. 46-Wheel Spindle and Support Cross-Section (Corvette)

assembly is installed.

d. Pack outer bearing with a high-melting point

wheel bearing lubricant and position on spindle.

Large end of bearing should be toward shoulder

e. Press bearing on spindle using a bearing spacer

and Tool J-9436 as installers, as shown in Fig-

5. Pack spindle inner bearing with a high-melting point

-wheel bearing lubricant and position bearing in

spindle support - small end of bearing should be

positioned inward.

Fig. 48—Installing Spindle Bearing Cup (Corvette)

Fig. 49—Unseating Drive Spindle Outer Bearing (Corvette)

Fig. 47—Bearing Cup Removal (Corvette)

Fig. 50—Removing and Installing Drive Spindle

Outer Bearing (Corvette)

CHEVROLET CHASSIS SERVICE MANUAL