Table of Contents
Advertisement
BUMPERS 14-2
placed in the tab of each bumper bracket. Dial the
adjustment washers in the tabs as required to posi-
tion the bumper at the correct mounted height
3. Tighten all bolts securely, connect parking lamp wir-
ing, and lower vehicle.
REAR BUMPER ASSEMBLY (Fig. 2)
Removal
1. Raise and support rear end of vehicle.
2. Disconnect rear license plate lamp wiring.
3. On Caprice models, disconnect back-up lamp wiring.
4. Remove center face bar to frame attaching bolts lo-
cated behind license plate door.
5. Remove bolts from each side "attaching bumper
brackets and braces to frame.
6. Remove bumper from vehicle.
Fig. 1 - Front Bumper Assembly - Chevrolet
FILLER
STAPLE
VIEW B
\
^ 7
^ ^
B
ALL EXCEPT STATION WAGON
Fig. 2 - Rear Bumper Assembly - Chevrolet
Disassembly
1. Remove license plate lamp.
2. On
Caprice
models,
remove
assemblies.
Remove bolts
3.
back-up
lamp
each bumper brace to
retaining
bumper.
4. Remove bolts retaining each bumper bracket to
bumper and separate sections of face bar at joints.
5. The license plate door (sedan models) and bumper
pads (station wagon models) may be removed by re-
moving the attaching parts shown in Figure 2.
Assembly
On Caprice models, attach both back-up lamps to cen-
ter face bar and tighten bolts firmly. Assemble the rear
bumper following the disassembly procedure in reverse
order. Except for back-up lamp attachments on Caprice
models, install all bolts loosely; do not tighten any bolts
until all bolts are installed.
Installation
1. Position bumper assembly on vehicle aligning holes
in braces and mounting brackets with those in frame,
2. Loosely install bolts, lock washers, and nuts includ-
ing center face bar to frame bolts behind license
plate door. Note that eight sided adjustment washers
(fig. 2) are placed in the tab of each bumper mounting
bracket. Dial the adjustment washers in the tabs as
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
