Table of Contents
Advertisement
ENGINE-ELECTRICAL 6Y-15
L
RELAY
TERMINAL
" F " TERMINAL
"BAT"
\
'
/
TERMINAL /
/
/
GRD7 TERMINAL
5 . 5 " SERIES I D DELCOTRON
" B A H "
TERMINAL
^
Vs
^^^^lij
B
i
i
^^8C^3^SH|j^^^^^^sH^^Bf-
y /
RELAY
^ ^ ^ " ^ ^ ^ j W w I i ^ ^ ^ ^
RELAY
6.2" SERIES 2D, TYPE 150 DELCOTRON
Fig. 14c—Delcotrons - Full View
end or use Adapter J-21501 and a box wrench) on re-
taining nut, insert a 5/16" alien wrench through
socket and adapter into hex on shaft to hold the shaft
while removing the nut.
2. Remove washer and slide pulley from shaft.
3. To install, slide pulley and washer on shaft and start
the nut.
4. Use the socket and adapter with a torque wrench and
tighten-nut to 50 ft. lbs. torque.
BRUSH REPLACEMENT
6.2" Delcotron
1. Remove two nuts retaining the blade connectors and
remove the connectors (fig. 17c). Slide the indicator
light relay wire from the terminal post.
2. Remove two screws retaining the capacitor and brush
holder to rear end frame, Remove brush holder.
3. To install brushes, push brushes into holder and
install pin to keep the brushes in holder.
4. Attach brush assembly and condenser to the end
frame with hex-head stud on the .left side only.
Fig. 15c—Pulley Removal
Fig. 16c—Torqulng Pulley Nut
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
