Table of Contents
Advertisement
REAR SUSPENSION AND DRIVE LINE 4-42
Fig. 113—Rear Suspension Special Tools (Chevrolet, Camaro, Chevelle and Chevy II)
1. J-8614
2. J-21057
3. J-21468
4. J-5748
5. J-21830
6. J-7574
7. J-7877
8. J-21474
9. J-9458
Companion Flange Remover—Consists of J-8614-1
Holder, J-8614-2 Nut and J-8614-3 Screw.
Drive Pinion O i l Seal Installer—Heavy-Duty Axle.
Drive Pinion O i l Seal Installer—Light Duty
Axle—Used with J-9458.
Positraction Torque Measuring Adapter.
Upper and Lower Control Arm Bushing P u l l e r -
Consists of J-21830-2 Adapter, J-21830-4 Receiver,
J-21830-7 Bridge—Used with J-21058-6 Spacer,
and J-21830-3 Spacer.
Chevrolet Lower Control Arm Front Bushing
Remover/Installer—Consists of J-7574-4 Receiver,
J-7574-1 Remover, J-7574-2 Installer Adapter,
J-7574-3 Spacer.
Chevrolet Tie Rod Bushing Remover/Installer—Consists
of J-7877-1 Remover Adapter, J-7877-2 Bushing
Receiver, J-7877-3 Installer Adapter—Used with
j-7079-2 Handle.
Chevelle Control Arm Bushing Remover—Consists of
J-21474-5 Receiver, J-21474-1 Spacer and
J-21474-2 Adapter.
Drive Pinion O i l Seal Installer—Light Duty
Axle—Used with J-21468.
10. J-21051
Rear Wheel Bearing and O i l Seal Installer-
Heavy Duty Axle—Used with J-7079-2.
11. J-21491
Rear Wheel Bearing and O i l Seal Installer—Light
Duty Axle—Used with J-8092.
12. J-2619
Rear Wheel Bearing and Oil Seal Remover (Slide
Hammer).
13. J-8119
Rear Wheel Bearing and O i l Seal Remover—Used
with J-2619.
14. J-21058
Upper and Lower Control Arm Puller—Consists of
J-21058-15 Screw and J-21058-8 Nut—Used
with J-21830.
15. J-8092
Driver.Handle—Threaded Type.
16. J-7079-2 Driver Handle—Insert Type.
17. J-21548
Propeller Shaft " U " Joint Trunnion Seal Installer.
18. J-21991
Chevelle Upper Control Arm Carrier- Bushing
Remover Adapter.
19. J-5853
Torque Wrench—In. lbs.
20. J-5810
Torque Wrench Adapter (3/4" to 3/8")
2 1 . J-1313
Torque Wrench—ft. lbs.
Tools Not Illustrated
J-22553
Rear Spring Front Bushing Remover/Installer Consists
of J-22553-1 Receiver, J-22553-2 Installer—Used
with J-21978-1 Receiver, J-21058-8 Nut and
J-21058-15 Puller Screw.
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
