Table of Contents
Advertisement
CLUTCH AND TRANSMISSIONS 7-39
LINKAGE ADJUSTMENT
1. Set lever (D) & control lever (E) in "Drive" detent.
2. Apply Forward load (Y) on lever (G) to Fully
seat lever (E) in "Drive".
3. Place a %4" spacer (H) between nut (A) & Swivel (J),
run nut (A) to spacer. Remove spacer & apply
rearward load (X) until lever (G) touches nut (A).
Tighten nut B.
4. Check shift pattern in all ranges, readjust
if required.
LEVER (E)
LEVER (D)
ACTUATING LEVER (G)
LOAD (Y)
SWIVEL (J)
NUT (A)
GROMMET
Fig. 2T - Gearshift Controls (console) - Typical
Installation
Installation of the pressure regulator valve is the re-
verse of the removal.
CONTROL VALVE BODY
Removal
1. Remove bottom pan and strainer.
2. Disconnect solenoid lead from connector terminal.
3. Remove control valve body attaching screws and de-
tent roller spring assembly.
NOTE:
Do not remove solenoid
attaching
screws.
4. Remove control valve body assembly and governor
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
