Table of Contents
Advertisement
STEERING 9-5
Fig. 8—Steering Column Wiring Connector
Secure with washer and nut. Refer to torque speci-
fications at rear of manual for correct torque values.
Install belleville spring (with dish of spring up), pivot
ring, bushing and receiving cup with screws.
Install retainer and horn button cap or center
ornament.
Connect steering column harness to chassis wiring
connector.
Fig. 9—Removing Steering Wheel with J-2927
Fig. 10—Simulated Wood Steering Wheel and Attaching Parts
SIMULATED W O O D (Fig. 10)
Removal
1. Disconnect steering column harness from chassis
wiring harness at connector.
2. Remove horn cap assembly by pulling up.
3. Remove contact assembly attaching screws and re-
move contact assembly.
NOTE: If steering wheel only is to be replaced,
perform step 4. If directional signal cancelling
cam is to be replaced, omit step 4 and proceed
with steps 5 and 6.
4. Remove remaining screws from steering wheel and
remove wheel from hub assembly.
5. Remove steering wheel nut and washer.
6. Using Tool J-2927, install centering adapter on
steering shaft, thread puller anchor screws into
threaded holes provided in hub assembly. Turn
center bolt of tool clockwise to remove hub
assembly.
Installation
CAUTION: Directional signal control assembly
must be in neutral position when assembling hub
assembly to prevent damage to cancelling cam
and control assembly.
1. With directional cancelling cam and horn contact in
place, install hub assembly on steering shaft. Secure
with washer and nut. Refer to torque specifications
at rear of manual for correct torque value.
2. Attach steering wheel to hub assembly using the six
attaching screws and tighten securely.
3. Place horn contact on steering wheel and attach with
three screws. Tighten securely.
4. Snap horn button in place.
5. Connect steering column harness to chassis wiring
connector.
CORVETTE TELESCOPING (Fig. 11)
Removal
1. Disconnect
steering column harness at wiring
connector.
2. Pry off horn button cap.
3. Remove three screws securing horn contact to spacer
and hub.
4. Remove two screws securing lock screw to lock
knob, and remove lock screw, lock knob, and spacer.
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
