Table of Contents
Advertisement
STEERING 9-6
Fig. 11 —Corvette Telescoping Wheel Option
5.
7.
NOTE:
If steering wheel only is to be replaced,
perform Step 5 below only. If directional signal
cancelling cam is to be replaced, omit Step 5
and proceed with Steps 6 and 7.
Remove six screws securing steering wheel to hub
and remove wheel.
Remove nut and washer from shaft and using steering
wheel puller Tool J-2927, remove steering wheel and
hub from vehicle.
Slide cancelling cam and spring off shaft.
Installation
NOTE:
Refer to torque specifications at rear of
manual for correct torque values.
1. If necessary, slide cancelling cam and spring on end
of shaft.
2. If hub was removed from steering wheel, attach hub
to steering wheel with screws removed during dis-
assembly.
3. Place steering wheel and hub assembly in position
and secure to column with washer and nut.
4. Position spacer on steering wheel.
5. Position lock knob on steering wheel.
6. Install lock screw through lock knob, turn into shaft,
and adjust to lock position.
7. Attach spacer to wheel with three screws.
8. Place lock knob in lock position and attach to lock
screw with two screws.
9. Remove three screws holding spacer. Attach horn
contact to spacer and steering wheel with three
screws.
10. Install horn button cap.
11. Connect steering column harness at chassis plug.
STEERING COUPLING (Fig. 12)
Removal
NOTE:
Chevy n models are equipped with a
clamp arrangement rather than the conventional
"rag joint" steering coupling. Refer to Steering
Gear - Chevy II, for service procedures.
1. Remove nuts and washers securing steering coupling
to flanged end of steering column (fig. 12).
2. Remove coupling clamp bolt (fig. 12) and slightly
spread coupling clamp.
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
