Heating And Air Conditioning Specifications; Front Suspension Specifications; Wheel Alignment Specifications - Chevrolet 1967 Chevelle Service Manual

SPECIFICATIONS
HEATING AND AIR CONDITIONING
SECTION 1A
Compressor
Make Frigidaire
Type . 6 Cylinder Axial
Displacement
Four-Season 12.6 Cu. In.
Universal and Ail-Weather . . . . .10.8 Cu. In.
Rotation Clockwise
Compressor Suction and Discharge
Connector Bolt Torque . . . . . . . 25 f t lbs.
Compressor Clutch Coil
Ohms (at 80°F.). 4.18-4.38
Amps (at 80°F.) 2.86 @ 12 Volts
Torques
Rear Head to SheU Stud Nut 23 lb. f t
Shaft Mounting Nut 15 lb. f t
Belt Tension. See Tune-Up Chart
System Capacities
Refrigerant R-12
Four-Season and Comfortron
Systems. . . . . . . . . . . . . 3 lbs., 12 oz.
Universal Systems
Chevrolet, Chevelle, and Camaro. . . . 3 lbs.
Chevy n 2 lbs. 8 oz.
All-Weather System 2 lbs. 8 oz.
Compressor Oil 525 Viscosity
All Systems 11 oz.
Fuses
Comfortron Systems .
Four-Season Systems .
Universal Systems . .
All-Weather System. .
Fuse
Block
25 amp.
25 amp.
25 amp.
25 amp.
In
Line
30 amp.
30 amp.
20 amp.
20 amp.
SECTION 3
WHEEL ALIGNMENT SPECIFICATIONS (Vehicle dt Curb Weight)
Caster*
Camber*
Steering Axis
Inclination
tToe-In (Total)
Wheel Bearing
Adjustment
Preload
End Movement
Chevrolet
Pos. 3/4° ± 1/2°
Pos. 1/4° ± 1/2°
7-1/2° ± 1/2°
@l/8" to 1/4"
12 ft lbs.
zero
.001" to .008"
Chevelle •
(SS and El Camino)
Neg. 1/2° ± 1/2°
(All others)
Neg. 1° ± 1/2°
Pos. 1/2° ± 1/2°
8-1/4° ± 1/2°
1/8" to 1/4"
12 ft lbs.
zero
.001" to .008"
Chevy n
Pos. 1° ± 1/2°
Pos. 1/2° ± 1/2°
7° ± 1/2°
1/4" to 3/8"
12 ft lbs.
zero
.000" to .004"
Corvette
Pos. 1° ± 1/2°
Pos. 3/4° ± 1/2°
7° ± 1/2°
3/16" to 5/16"
12 ft lbs.
zero
.001" to .008"
Camaro
Pos. 1/2° £ 1/2°
Pos. 1/4° ±1/2°
8 3/4° ± 1/2°
1/8" to 1/4"
12 ft lbs.
zero
.001" to .008"
•Must not vary more than 1/2° from side to side.
@Toe-In (Total) should be 5/16" to 7/16" after rebuild using new bushings and ball joints.
tAdjust Toe-in with steering gear on straight ahead location after camber and caster have been set Any change
in caster and camber settings will affect toe; always recheck and set toe to specifications.
LET CHASSIS SERVICE MANUAL