Removing Pivot Shaft Bushing - Chevy Ii; Installing Pivot Shaft Bushing - Chevy Ii; Removing Upper Control Arm Cross Shaft Bushings; Installing Upper Control Arm Cross Shaft Bushing - Chevrolet 1967 Chevelle Service Manual

FRONT SUSPENSION 3-24
Fig. 39 - Removing Pivot Shaft Bushing - Chevy II
4. Install collar, lock washer and cap screw in ends of
cross shaft. Do not tighten.
Chevy II
Removal
If a new pivot shaft is to be installed, always replace
both pivot shaft bushings.
1. Remove nut, lock washer and metal spacer from
pivot shaft end.
2. Stand control arm and pivot shaft assembly on
Support J-5888-3.
V
f
ff
3
/a x 24
y * CAP SCREW
k
a
4f TOOL
i J-5888-3
• •
Fig. 41 - Removing Upper Control Arm Cross Shaft Bushings
3. Insert J-9513-1 over threaded end of pivot shaft.
4. Press pivot shaft down until upper bushing diameter
is visible for approximately 5/16", then insert
J-9513-2 over journal. Release tension on pivot
shaft.
5. Invert control arm, support on J-5888-3 and press
out bushing with J-9513-1 (fig. 39).
6. Press remaining bushing out in the same manner.
TOOL
J 7052-5
Fig. 40 - Installing Pivot Shaft Bushing - Chevy II
Fig. 42 - Installing Upper Control Arm Cross Shaft Bushing
CHEVROLET CHASSIS SERVICE MANUAL