Table of Contents
Advertisement
CLUTCH AND TRANSMISSIONS 7-15
LOCATING
GAGE B
N
Fig. 1C - Warner T-16 3-Speed Lever and Linkage Adjustment (Camaro and Corvette)
Clearance should be .002 to .008. Interlock sleeves
are
available in four sizes to give the proper
clearance.
6. Install outer shifter levers to shafts with lock wash-
ers and nuts. Tighten securely.
v
7. Instill shifting forks to shift levers (1st and re-
verse fork "hump" towards bottom).
Installation
1. Install new side cover gasket to transmission case,
install cover and secure with lock washers and cap
screws.
NOTE:
The two rear side cover to case at-
taching bolts have a special oil sealing spline
and must be used at these two "through" hole
locations.
2. Connect control rod and cross shaft to control
levers.
1. Side Cover
2. Poppet
3. 1st and Reverse Shifter
Lever and Shaft
4 . Poppet Spring
5. 1st and Reverse Shifter
Fork
6. Interlock Pin
7. 2nd and 3rd Shifting
Fork
8. Interlock Sleeve
9. 2nd and 3rd Shifter
Lever and Shaft
10. "O
11
Ring Seal
Fig. 2C - Side Cover Assembly - Layout
CHEVROLET CHASSIS SERVICE MANUAl
Advertisement
Table of Contents
