Chevrolet 1967 Chevelle Service Manual page 529

ELECTRICAL-BODY AND CHASSIS 12-17
Fig. 25 - Shaft Retainer
2. Disconnect switch wiring from harness wiring at
in-line connector.
3. Remove bolt retaining wiring attaching clip to
transmission. * • ' •
4. Remove wire clip retaining reverse lever rod to
switch.
5. Remove screws retaining switch and shield assembly
to transmission, remove switch.
NOTE: Do not remove transmission-to-bracket
retaining bolts.
6. To install, reverse removal procedure and check
switch for operation in transmission reverse range.
.38-.64"
VIEW A
Fig.-27 - Stoplight Switch Assembly
NEUTRAL SAFETY SWITCH REPLACEMENT
Column Shift (Fig. 31)
1. Disconnect wiring harness connectors at switch ter-
minals..
2. Remove switch retaining screws and switch from
mast jacket.
3. To install, position shift lever in drive and locate
lever tang against transmission selector plate.
4. Align slot in contact support with hole in switch and
insert pin (3/32" dia.) to hold support in place.
Switch is now in drive position.
5. Place contact support drive slot over shifter tube
drive tang and tighten screws. Remove clamp and
pin.
6. Connect wiring harness to switch terminals and
check operation of switch.
Floor Shift
Chevrolet, Chevelle, Chevy II and Camaro
(Fig. 31)
1. Position shift lever in drive position. Remove ash
Fig. 26 - Windshield Wiper Switch
Fig. 28 - Dimmer Switch
CHEVROLET CHASSIS SERVICE MANUAL