CORVETTE BODY 1B-36
Fig. 74-Finishing Plastic Solder Repair
Fig. 77—Applying Laminate to Body
Fig. 75—Grinding "V" at Damaged Area
pig. 76—Applying Resin Mixture to Fiber Glass
the under side of both portions of the panel. Also,
remove paint and scuff area clean to provide a
good bonding surface.
Remove all cracked and fractured material along
the break: Bevel the attaching edges of the panels
at approximately a 30° angle with a file or grinder
and scuff plastic surfaces along edges of break.
Fig. 78—Typical Scratched Panel
Fig. 79—Repair Area Finish Sanded
NOTE:
Mask surrounding panels using a non-
staining masking tape.
CHEVROLET CHASSIS SERVICE MANUAL