Table of Contents
Advertisement
CLUTCH AND TRANSMISSIONS 7-22
Fig. 2X - Shift Linkage (Chevy II)
3. Install Reverse Rod (J) with Retainer on Lever (N).
4. With two Jam Nuts and Swivel loose on Rod (J) insert
and attach Swivel with Retainer to Lever (E).
5. Maintaining Lever (E) against Locating Gauge (B)
while holding Swivel run front Jam Nut against Swivel
then tighten rear Jam Nut against Swivel to specified
torque.
6. Install Rod (O) with Retainer on Lever (M)
o
7. With two Jam Nuts and Swivel loose on Rod (O) insert
and attach Swivel with Retainer to Lever (C).
8. Repeat Step 5 Maintaining Lever (C) against Locating
Gauge (B).
9. Install Rod (K) with Retainer on Lever (L).
10. With two Jam Nuts and Swivel retain to Lever (D).
11. Repeat Step 5 maintaining Lever (D) against Locating
Gauge (B).
12. Remove Locating Gauge and check shift to insure
proper operation. Readjust if necessary.
N
<
^ ii
K
3
A
1-2 DETENT
CAM
PIVOT PIN
DETENT
SPRING
3-4 DETENT
CAM
3-4
SHIFT FORK
1-2 SHIFTER
SHAFT ASSY.
REVERSE
SHIFTER SHAFT
ASSY.
3-4 SHIFTER
SHAFT ASSY.
DETENT SPRING
RETAINER
& BALL (UNDERNEATH) 1-2 SHIFTER
R
,
N G
FORK
F i g . 3X - Comoro and Corvette Shift Linkage
F i g . 4X - Transmission Side C o v e r / Shift Fork and Detent Assembly
TRANSMISSION SIDE COVER
Removal
1. Disconnect control rods from levers.
2. Shift transmission into neutral detent positions be-
fore removing cover.
3. Remove cover assembly from transmission case
carefully and allow to drain.
Disassembly (Fig. 4X)
1. Remove the outer shifter levers.
2. Remove both shift forks from shifter shaft assem-
blies. Remove all three shifter shaft assemblies
from cover. "O" ring seals around shifter shaft
may now be pryed out if required because of damage.
Remove reverse shifter shaft detent ball and spring,
3. Remove detent cam spring and pivot retainer "C"
ring. Mark to identify for reassembly, then remove
both detent cams.
4. Replace damaged parts.
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
