Table of Contents
Advertisement
CHASSIS SHEET METAL 11-17
Fig. 2 8 - Hood Spring Removal
Installation
Skirt installation is written for the installation of a
stripped skirt, with suspension and otiier parts added
after skirt is attached to vehicle. Proceed as follows:
1. Position skirt assembly on vehicle with insulator,
shown in Figure 26, in place and original shims in-
stalled at top dash mount
2. Install the three bolts at top mount and four bolts at
lower dash brace.
3. Install front crossmember, replacing the four bolts
and nuts removed previously.
4. Replace engine mount cushion; refer to Section 6.
5. Install front suspension parts as outlined in Sec-
tion 3. Connect stabilizer link to stabilizer (if so
FINAL POSITION
Fig. 30 - Installing Hood Molding Clip
equipped) and connect tie rod end to steering arm as
outlined in Section 9.
6. Install radiator support and fender assembly as out-
lined in this section. Install grille (Section 13).
7. If left skirt was removed, proceed as follows:
a. Install steering gear. Carefully follow outline
under Steering Gear - Installation in Section 9.
Do not fail to perform adjustments listed under
Mast Jacket Installation in that section.
b. Install clutch cordon shaft (if so equipped).
c. Install power steering hose clamp (if so equipped).
8. Install brake lines and bleed brakes as outlined in
Section 5.
9. Install hood and adjust as outlined in this section.
10. Perform following checks and adjustments:
a. Check and adjust front body section alignment
as outlined in Fisher Body Service Manual.
Fig. 29 - Installing Tool J-9559 in Nev/Spring
Fig. 31 - Removing Front End Assembly from Vehicle
CHEVROLET CHASSIS SERVICE MANUAL
Advertisement
Table of Contents
