Heat Damper Operation - kozy heat MINNETONKA 55345-MV Installation Manual

FINALIZING THE INSTALLATION
TO ADJUST FRONT BURNER VENTURI:
1. Follow Control Board Removal instructions on page 22 to access and remove
front burner assembly.
2. Loosen screw on venturi and adjust as necessary. Tighten screw.
3. Follow Control Board Installation instructions on page 23 to reinstall all
components.
This fireplace has been designed to operate with the damper fully open or completely closed depending on desired heat output without
compromising flame appearance.
The damper is located at the inside top of firebox and can be viewed through the glass. The damper control is located under the firebox.
To reduce the amount of heat entering the room, raise damper control up and push into mounting slot. The damper is now in the fully open
position and allows more heat to exit through the vent system.
If more heat is desired, pull handle out and down. The damper is now closed.
Figure 27b
HEAT DAMPER
27
Figure 27a
Damper