Seasonal Heat Dump Operation - kozy heat 944 SEE-THRU Installation & Operating Instructions Manual

WARNING: DO NOT ENCLOSE THE AIR SPACE AT THE BOTTOM OF THE FIREPLACE. THIS COULD CAUSE
THE AREA TO OVERHEAT.
MASONRY CONSTRUCTION:
CAUTION: The surrounding wood chase of the outside wall MUST be insulated to prevent cold air from
entering the room.
2. SEASONAL HEAT DUMP POSITION:
This fireplace has been designed with an adjustable heat dump outlet located in the baffle inside the fireplace (at the top).
This will allow infinite control over the amount of heat emitted into the living area without affecting the flame height.
INSTALLER: PLEASE INSTALL THIS FIREPLACE WITH THE ADJUSTABLE HEAT OUTLET DUMP IN ITS CLOSED
POSITION.
HOMEOWNER: The fireplace has been installed with the heat dump in the closed position and will operate at its peak
efficiency. The heat dump may be opened as much as necessary to maintain heat level.
TO ADJUST:
CAUTION: DO NOT ATTEMPT TO ADJUST THE HEAT DUMP OPENING IF THE FIREPLACE HAS BEEN IN OPERATION.
ALLOW AMPLE TIME TO COOL OR USE THE APPROPRIATE PROTECTION TO AVOID SERIOUS BURNS AND / OR
PROPERTY DAMAGE.
1. Remove the 'front' glass assembly and set aside where it will not be broken. Refer to page #5.
2. Locate the heat dump damper handle in the baffle and adjust opening to amount desired.
3. Replace the front glass assembly.
NOTE: The more open the heat dump, the less heat that will be emitted into the living area. This enables you to operate the
fireplace for a longer period of time without overheating the room.
Figure 16
3. THIS STEP SHOULD ONLY BE DONE BY A QUALIFIED INSTALLER OR SERVICE TECHNICIAN:
A) Perform lighting and shutdown procedures as described on pages #26-27. This should be done prior to replacing
the glass so that any necessary adjustments can be made and proper operation verified.
4. Replace the front & back glass assemblies. Refer to page #5.
A. Align the slots in the top of the glass assembly over the tabs on the fireplace.
B. Place the glass assembly so it is flush with the front of the fireplace front.
FIREPLACE 'FRONT' SIDE:
A. Secure the assembly to the fireplace by pushing the two spring loaded handles (located under the firebox) back, locking
them into position.
If using a lintel iron, follow instructions included with the lintel iron for proper
placement.
HEAT OUTLET SHOWN IN PARTIAL OPENED POSITION.
Page 24