System Operations - kozy heat MINNETONKA 55345-MV Installation Manual

INITIALIZING THE SYSTEM FOR THE FIRST TIME
1. Set ON/OFF rocker switch to OFF position.
2. Install 4 AA batteries (included in components packet) into battery backup holder.
3. Connect IFC Control Module to AC power supply.
4. Install 3 AAA batteries (included in components packet) into remote control
battery bay (located on base of remote control).
NOTE: Per for ming the next step will initiate Pilot Star t-up in Manual Mode:
Pilot igniter will spark repeatedly.
Pilot will ignite if gas is supplied to the fireplace.
Remove all packaging / combustible material from fireplace before proceeding.
5. Press red SW1 button on IFC control module until module beeps three (3) times and/or an amber LED is illuminated indicating the IFC
control module is ready to synchronize with the remote control .
Within ten (10) seconds push remote control ON/OFF button. The IFC control module will beep (4) times to indicate the remote
6.
control's command is accepted and set to the particular code of that remote control. Press remote control ON/OFF button again. The
pilot will shut down indicating the remote has taken over. The system is now initialized.
7. Setting ON/OFF rocker switch to ON position will allow you to operate fireplace with remote control.
TEMPERATURE DISPLAY
With the system in OFF position, press Thermostat Key and Mode Key at the same
time to change from degrees F to C. Look at remote control LCD screen to verify that
C or F is visible on right side of Room Temperature display.
TURN ON THE APPLIANCE
Press ON/OFF key on remote control. The display will show all active icons on the screen. A single 'beep' from IFC Control Module will
Confirm reception of the command.
TURN OFF THE APPLIANCE
Press ON/OFF key on remote control. The display will show only room temperature and icon on the screen. A single 'beep' from IFC
control module will confirm reception of the command.
MANUALLY CONTROL FLAME WITH REMOTE CONTROL
The remote control has six (6) flame levels. With system ON and flame level at maximum, press Down Arrow Key once to reduce flame
height by one step until flame is turned off. The Up Arrow Key will increase flame height on step each time it is pressed. If Up Arrow Key
is pressed while system is on but flame is off, the flame will come on in High position. A single 'beep' will confirm reception of the
command. When SMART Thermostat is activated, manual flame height adjustment is disabled.
Figure 6c
SYSTEM OPERATION
6
LEDs
SW1 Button
IFC Control Module
Figure 6a
Figure 6b