kozy heat MINNETONKA 55345-MV Installation Manual page 24

#MTK-50A LOG SET INSTALLATION
If converting to LP (propane) gas or installing optional light kit do so now before installing log set. Follow instructions included
ATTENTION
with kit. (Sold separately).
NOTE Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
CAUTION
soot to build up on logs and glass.
Figure 21a
Position log #1 onto burner, setting backside of log against flange
at back. Pull log forward approximately 1/2" (13mm).
#4
Figure 21c
Position log #4 as shown. Install #11 log over burner jumper tube.
Figure 21e
Align notch in log #12 to log grate while positioning bottom
mounting hole to protrusion in log #8.
#1
#11
#12
21
#2
Figure 21b
Position logs #2, #3 & #6 onto burner as shown above.
#7
#10
Figure 21d
Position logs #7 - #10 onto base logs, aligning holes in logs to
protrusions on base logs and log grate.
Figure 21f
Randomly place 'Klinkers' in this area. Do not place 'Klinkers'
directly on burner ports.
Use a steel or stiff bristle nylon brush to distribute Rock Wool
Embers onto logs and burner.
#6
#3
#8 #9