Gas Line Connection - kozy heat MINNETONKA 55345-MV Installation Manual

Direct vent gas fireplace

Table of Contents

GAS CONVERSION

This fireplace is manufactured for use with Natural Gas. Follow instructions included with conversion kit if converting to LP gas. (Sold

separately).

PLEASE REFER TO SUPPLEMENTAL MANUAL FOR INFORMATION REGARDING PROPER MANIFOLD PRESSURE

ATTENTION

READINGS FOR YOUR PARTICULAR FIREPLACE MODEL.

The conversion shall be carried out in accordance with the requirements of the provincial authorities having jurisdiction and in

ATTENTION

accordance with the requirements of the ANSI Z223.1 installation code.

Installation of the gas line must only be done by a qualified person in accordance with local building codes, if any.

If not, follow ANSI 223.1.

CAUTION

Commonwealth of Massachusetts: Installation must be done by a licensed plumber of gas fitter.

A listed (and Commonwealth of Massachusetts approved) 1/2" (13mm) T-handle manual shut-off valve and flexible gas

connector (included) are connected to the 1/2" (13mm) control valve inlet. If substituting for these components, please consult

local codes for compliance.

This fireplace is equipped with a 3/8" (10mm) x 18" (457mm) long flexible gas connector and manual shut-off valve. The gas

line should be run to the point of connection where the shut-off valve and flexible gas line will connect.

NOTE

The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure

testing of that system at pressures in excess of ½ psi (3.5 kPa).

The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any

pressure testing of the gas line at test pressures equal to or less than ½ psi (3.5 kPa).

For high altitude installations, consult the local gas distributor or the authority having jurisdiction for proper rating methods.

The efficiency rating of this appliance is a product of thermal efficiency rating determined under continuous operating

IMPORTANT

conditions and was determined independently of any installed system.

MINIMUM INLET GAS PRESSURE

MAXIMUM INLET GAS PRESSURE