Nomadix Access Gateways User Manual page 101

A G
CCESS ATEWAY
2. Enter your location information in the following fields:
Company Name

Site Name

Address (Line 1 and Line 2)

City, State, Zip, and Country

E-mail Address

ISO Country Code

Phone Country Code

Calling Area Code

3. Select the area type that most resembles your location from the drop down list.
4. Enter a Network SSID/Zone
To enable the 802.1Q tag for:
5.
System traffic, check the box

if necessary, enter the tag number.
Changing these settings could result in loss of connectivity.
Subscribers traffic, check the box

Traffic
Changing these settings could result in loss of connectivity.
You must reboot the system if you make changes to any of the following IP
settings.
You may lose your connection if you change the IP settings incorrectly (using
invalid IP addresses). If you "misconfigure" the Access Gateway and network
connectivity is lost, you can still access the Access Gateway from the Command
Line Interface (CLI) via a direct serial connection. In this case, refer to:
Powering Up the System
System Administration
.
, and if necessary, enter the tag number..
Enable WAN 802.1Q header for System Traffic
Enable WAN 802.1Q header for Subscribers
and "Logging In" on page 53.
, and
89