Bedbar Assembly - Toro Reelmaster 5210 Service Manual

Bedbar Assembly

5
4
RIGHT
FRONT
1. Bedbar
2. Bedknife
3. Screw (8 used)
4. Bedbar adjuster shaft (2 used)
5. Flange bushing (4 used)
6. Cap screw (2 used)
7. Detent (2 used)
Bedbar Removal (Fig. 19)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. Remove the cutting unit from the machine. Use the
cutting unit kickstand to support the cutting unit (see
Special Tools).
3. Loosen the lock nuts (item 13) on the end of each
bedbar adjuster assembly until washer (item 11) is
loose.
Cutting Units (Rev. C)
10
6
7
9
8
5
Figure 19
8. Wave washer (2 used)
9. Retaining ring (2 used)
10. Bedbar adjuster screw (2 used)
11. Washer (2 used)
12. Compression spring (2 used)
13. Lock nut (2 used)
Page 7 - - 16
7" CUTTING REEL SHOWN
13
12
11
3
16
14. Rubber bushing (2 used)
15. Flange bushing (2 used)
16. Plastic washer (4 used)
17. Metal washer (2 used)
18. Bedbar pivot bolt (2 used)
19. Lock nut (2 used)
4. Loosen the lock nuts (item 19) on each bedbar pivot
bolt (item 18).
5. Remove two (2) bedbar pivot bolts (item 18), two (2)
metal washers (item 17) and four (4) plastic washers
(item 16) from the cutting unit side plates.
1
2
27 to 33 ft- -lb
(37 to 44 N- -m)
14
15
16
17
18
19
Antiseize
Lubricant
Reelmaster 5010 Series