Lift Cylinder Service - Toro Reelmaster 5210 Service Manual

Lift Cylinder Service

30 to 35 ft- -lb
(41 to 47 N- -m)
14
1
1
1. Grease fitting
2. Shaft
3. Wiper
4. Head
5. U- -Cup
NOTE: The front, center lift cylinder is shorter with less
stroke than the other lift cylinders which are identical.
Service procedures for all lift cylinders used on Reel-
master 5010 machines are the same.
Disassembly (Fig. 89)
1. Remove oil from lift cylinder into a drain pan by slowly
pumping the cylinder shaft. Plug both ports and clean
the outside of the cylinder.
Hydraulic System (Rev. C)
9
11
13
12
10
13 9
11
12
6. Retaining ring
7. Back up washer
8. O- -ring
9. Piston
10. Cap seal
4
6
7
8
10
14
Figure 89
IMPORTANT: Prevent damage when clamping the
lift cylinder into a vise; clamp on the clevis end of
the barrel ONLY.
2. Mount lift cylinder securely in a vise by clamping on
the clevis end of the barrel. Use of a vise with soft jaws
is recommended.
Page 4 - - 104
1
2
3
5
6
7 4
8
2
5 3
11. O- -ring
12. O- -ring
13. Lock nut
14. Barrel
Reelmaster 5010 Series
1